Peugeot 208 Key Replacement
It is best to delegate the replacement of Peugeot keys 208 to auto locksmiths who have the equipment and knowledge. They can design and program keys faster and less expensive than dealers.
A dead battery for your coin is most likely to be the cause the reason why your key fob isn't locking or unlocking doors. There are other causes that the key might be malfunctioning.
Dead Coin Battery
A dead coin battery will stop your Peugeot 208 from locking or unlocking, and will not allow you to start the engine. If this is the scenario, you'll need use the backup starting method that's described in the owner's manual of your vehicle.
Another reason why the 208 won't start is because the spark plugs are worn down. Spark plugs are what ignite the fuel to start the engine. They are only able to last for a short time. They'll eventually break down if they aren't used frequently enough.
There is a simple solution to this issue. The best solution is to test the voltage of your car battery using a multimeter. If it is below 11.5 volts it is time to replace it. It is also important to clean the contacts of the battery when it has corrosion. You can do this by lifting the rubber covers covering the two terminals of the battery and using wire brushes to clean any corroded components of the battery. It is then time to reconnect your cables to connect the positive and negative poles.
Water Damage
If your 208 doesn't start and the battery hasn't gone flat, you should inspect the spark plugs. It could be that they are overly dirty, causing them not to spark. The spark plugs can be cleaned in an workshop.
Peugeot cars have keys that are transponder-type and works with the car's immobiliser system. This ensures that only the right key is able to turn the engine. If the chip inside the Peugeot key is damaged, it will not send the correct signal to the vehicle.
Water damage is a typical reason for this issue. This is a frequent issue in warmer climates where the vehicle is exposed to snow or rain. If this is the case, seek out a reputable auto locksmith who has all of the equipment and tools needed to modify the new key. They also have the most up-to-date technology and equipment needed to make a Peugeot 208 smart key. The process shouldn't take longer than 15 minutes.
Faulty battery contacts
Peugeot changed from the old carbon encased transponder chips to a brand new kind of chip that utilizes electronic components on circuit boards. The new system is fantastic when it's new, but the circuit boards wear out over time and cease to function properly.
This could stop the immobiliser from working, so the vehicle won't start. Contact a Peugeot specialist, or a locksmith if this is the case.
A common problem is when the battery of the key fob begins to die. This causes the blade of the key to stop feeding into your lock. A car locksmith will replace the battery, and cut a new blade for you. This is a simple solution.
Faulty Receiver Module
If your Peugeot key fob has stopped working after dropping it on the ground, being exposed to a sudden downpour or accidentally washing it may be due to a malfunctioning receiver module. The receiver module is responsible for transmitting radio frequency to the onboard computer which regulates the central locking system of your Peugeot vehicle.
Rubber seals on the key fob block water from reaching its electronic chip. The chip can be damaged by water when it is exposed to the water for an extended period of period of. Submerging the key fob into sea water at the beach or throwing it into the pool could be particularly damaging due to the high salt content.
The module will have to be replaced if your Peugeot spare key isn't working anymore. This can only be done by a Peugeot specialist or a professional auto locksmith. As opposed to other cars, Peugeot keys are protected by an unique immobilizer system that requires the correct coding in order to start the engine. This is why you must be able to trust a professional Peugeot locksmith with the task of programming and creating an appropriate replacement.
Faulty On-Board Computer
The on-board computer in your Peugeot is responsible for various functions in your car including airbags and power windows. If something is wrong with these systems, it will typically display a code indicating the problem. This code is saved in the system and will remain there until the problem is resolved. This will often require the on-board computers to be replaced.
The most frequent cause for the warning light of the airbag to come on is corroded or loose connections in the sensor. This could be due to wear and tear, aging, exposure to salt and moisture. www.g28carkeys.co.uk is imperative to have this issue resolved as soon as you can, as an airbag that is malfunctioning can be dangerous in the event an accident.
If you encounter a card not found error on your Peugeot, the key battery in the key fob may be weak or dead. This will prevent the key fob from transmitting a signal that will disable your vehicle's standard immobilizer. Try this by pressing the unlock button on the fob's key and then trying to start your car. If this doesn't work then the battery in the key will need replacing.